Furuno FS-2575 - Tx Pwr (Freq); Tx Pwr (User Ch)

3. INITIAL SETTINGS
3-4
FORMAT: Select sentence format. [IEC]: Sentences for IEC 61162 Ed.4 received.
[IEC+NMEA]: Sentences for IEC 61162 Ed.3 and NMEA received. [IEC+NMEA-EM]:
Sentences for IEC 61162 Ed.3 and NMEA received. However, GNS/GLL/RMC sen-
tences with a mode indicator of E or M are not received.
CH TABLE: Select channel table from [WRC-7] or [WRC-12]. Select [WRC-12] usu-
ally. If frequency clearance is not revised from country to country, select [WRC-7].
TX PWR (FREQ)
TX power can fluctuate on certain frequencies depending on antenna location. If this
occurs, adjust the TX power on the problem frequency.
TX MODE: Select the mode for which to set TX power.
TX FREQ: Select the frequency.
TX POWER: Set the output level.
TX POWER ADJ: Set the TX power.
TX TONE: Output tone.
LOAD DEFAULT: Restore default TX power (frequency) settings.
For details of the settings on the [TX POWER (FREQ)] menu, see the service manual
of FS-1575/2575/5075.
TX PWR (USER CH)
TX power on user channels can fluctuate according to antenna location. If this occurs,
adjust the TX power on user channels.
* Shown for FS-5075 only
IC1  x.xA*
IC2  x.xA*
VC2  x.xV*
PA1 current
PA2 current
VC of PA2
xx.xV
xx.xV
xx.xA
xx.xA
* Shown for FS-5075 only
IC1  x.xA*
IC2  x.xA*
VC2  x.xV*
PA1 current
PA2 current
VC of PA2
xx.xV
xx.xV
xx.xA
xx.xA