3. INITIAL SETTINGS
3-5
TX MODE: Select the mode for which to set TX power.
TX FREQ: Select the frequency.
TX POWER: Set the output level.
TX POWER ADJ: Set the TX power.
TX TONE: Output tone.
LOAD DEFAULT: Restore default TX power (user channel) settings.
For details of the settings on the [TX POWER (USER CH)] menu, see the service
manual of FS-1575/2575/5075.
3.4.5 OTHER menu
P-BROWSER : Select [ON] to enable the parameter browser, controlled from a PC.
ALARM UNIT : Select [CONNECT] if Alarm Unit IC-350 is connected.
AMS MODE : Select the AMS (alert management system) mode.
[LEGACY] (default): When [LEGACY] is selected, the FS-xx75 will not
input/output the following sentences:
• Input: ACK, ACN, HBT
• Output: ALC, ALF, ALR, ARC, HBT
[AlertIF1]: When AlertIF1 is selected, the FS-xx75 will input/output the
following sentences:
• Input: ACK
• Output: ALR
[AlertIF2]:When AlertIF2 is selected, the FS-xx75 will input/output the
following sentences.
• Input: ACN, HBT
• Output: ALF, ALC, ARC, HBT
To Next Page
Loading...
