1-1
1. HOW TO INSTALL THE SYSTEM
1.1 Control Unit FS-2575C
1.1.1 Installation location
• The location must not be near water, rain and water splash.
• Make sure the location is strong enough to hold the unit under the conditions of con-
tinued
vibration and shock normally found on the boat.
• Follow the compass safe distances shown in the Safety Instructions to prevent the
interference to a magnetic compass.
• Follow the recommended maintenance space shown in the outline drawing to allow
the serviceman to reach the connectors at the rear of the unit.
• Direct sunlight can cause the inside of the unit to become hot. Install the unit away
from direct sunlight.
• Connect the ground wire between the ground terminal and ship’s earth.
1.1.2 How to install the unit on a desktop
A bracket is provided to install the unit on a desktop.
1. Fasten the bracket to the installation location with the self-tapping screws.
2. Loosely screw in the knobs at the sides of unit.
3. Set the unit to the bracket and tighten the knobs.
Knob
Knob
Bracket
To Next Page
Loading...
