Furuno FS-5000 - Page 343

FELCOM 82
H3-14
4. Press [5], followed by [Enter] key.
5. Press [6], followed by [Enter] key to call “OID/DID Registration” menu.
2:Ship Position
3:Commitioning Request Switch
4:Telephony Baseband Port Switch
5:Frequency Measurement Switch
6:OID/DID Registration
E:Exit
Enter JOB No.:6
OID/DID Registration
TEL FAX ID
1:HSET _ _ 5:DATA _
2:TEL1 _ _ 6:TELEX _ ________
3:TEL2 _ _ 7:HSD(64k) _
4:TEL3 _ _ (54k) _
E:Exit
Enter No.:
6. Press numeric key corresponding to that on which line you enter the OID/DID,
followed by [Enter] key. For example, to enter FAX OID/DID for TEL3 line,
press [4], followed by [Enter] key.
TEL FAX ID
1:HSET 01 _ 5:DATA 21
2:TEL1 02 _ 6:TELEX 31 343199710
3:TEL2 03 _ 7:HSD(64k) 42 HSET
4:TEL3
_
11 (54k) 41
7. Type OID/DID, followed by [Enter] key.
Note)
1. TEL1 to TEL3 lines are used for either telephone or fax.
2. TELEX OID/DID must be entered together with the telex number.
3. To use the handset on the fax machine for voice communication,
a) Enter TEL and FAX OID/DIDs on the same line. For example, the
PFX-50 is connected to the TEL3 line, enter 02 and 11 on the TEL3 line.
Now the handset on the fax machine can be used as telephone.
b) Change the receive mode to TEL.
c) Prefix dialing is unnecessary.
4. In item number seven, a phone port may be selected to initiate a manually
dialed HSD call. For example, if TEL2 is selected, TEL2 may then be used
to DIAL an HSD call.
8. Press [Esc] to close the menu.
Communication Unit Setup