EasyManua.ls Logo

Furuno FS-5000 - Page 363

Furuno FS-5000
493 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FELCOM 82
H3-34
Synthesizer
- Rx SYN (OK/NG)
The local oscillator for the receiver consists of VCOs of 730 MHz and 815 MHz
bands and PLL ICs. When either PLL unlocks, the SYS CPU generates NG
signal.
- Tx SYN (OK/NG)
TX local oscillator, consisting of PLL and VCO oscillates between 1682.4 MHz
to 1702.56 MHz. When the PLL unlocks, the SYS CPU generates NG signal.
Antenna controls
- Antenna Status (REMOTE/FAULT)
When the SYS CPU communicates with the PCU in the antenna unit normally,
REMOTE is indicated. If not, FAULT comes on. At power-up, FAULT appears
until the antenna initialization is complete.
RF CON
U23
PLL IC
U15
PLL IC
815M
band
VCO-1
730M
band
VCO-2
FL5
FL7
Ref. 21.12MHz
Ref. 21.12MHz
1535.7
-1555.7MHz
Rx IF
10.7MHz
Rx RF
1525-1545MHz
CR8
CR9
Rx UNLOCK
U4,11
CONT
DATA
DATA
CONT
RF CON
U30
PLL IC
VCO
Ref. 21.12MHz
1682.4
-1702.56MHz
Tx RF
1626.5-1646.5MHz
CR7
U44
Tx UNLOCK
Tx IF
56MHz+120kHz
U35
CONT
DATA

Table of Contents

Related product manuals