Furuno FS-5075 - WR2 Board; Watch Receiver Kit (Type: OP05-123, Code No.: 001-135-610)

1. HOW TO INSTALL THE SYSTEM
1-12
1.6.8 WR2 Board
The WR2 Board (05P0847B) enables reception of DSC routine frequencies while us-
ing the SSB radiotelephone connection. See section 3.4.6 for antenna configurations.
Watch Receiver Kit (Type: OP05-123, Code No.: 001-135-610)
1. The Preamp Unit FAX-5 requires 12 VDC power. Set the jumper block J3 on the
WR2 Board to the ACTIVE position to supply power to the unit.
2. Open both the Transceiver Unit and the shield cover.
3. Fasten the WR2 Board with four screws (supplied) at the location shown below.
Name Type Code No. Qty
WR2 Board 05P0847B(LF) 001-137-100 1
Binding head screw M3×6 SUS304 000-163-485-10 6
Mini-pin assy. L-200 07S0046 000-165-847-10 1
Connector assy. MJ145-TMP-1.5D-L520 000-175-320-10 1
Shield case 03-161-1011-0 100-302-730-10 2
ACTIVE
Jumper block J3
Fasten WR2
Board here.