2. WIRING
2-9
2.1.2 Connections for outside installation
For outside installation, arrange the antenna wire as shown below. The optional an-
tenna materials shown below are necessary.
1. Make a loop (diameter approx. 120 mm) in the antenna cable at the insulator of
the Antenna Coupler.
2. Put the end of the antenna cable through the hole of the insulator and fasten the
bolt.
3. Prepare a piece of antenna wire (approx. 300 mm) and wind it around the insulator
one turn.
4. Fasten the above piece of wire and antenna wire together with the wire clips near
the ends of the piece of wire.
5. Coat the bolt with the silicone sealant.
Name Type Code No. Remarks
Antenna materials CP05-09010 005-954-180 w/10 m antenna cable
CP05-09020 005-964-410 w/25 m antenna cable
Piece of antenna wire
Bolt
Antenna wire
Wire clip
ANTENNA
COUPLER
Loop
Copper
strap*
* See the whip antenna outline
drawing for details.
To Next Page
Loading...
