3. INITIAL SETTINGS
3-2
2. Enter the password. The lock icon turns green, the shackle of
the lock opens and the cursor selects the MMSI area. Push the
Rotary knob to show the MMSI input box.
3. Use the numeric keys to enter the MMSI.
4. Push the Rotary knob to register the MMSI.
Note: You can re-enter the MMSI if it is wrong. Select [CLEAR] then push the Ro-
tary knob. You are asked "MMSI Clear OK?". Select [Yes] then push the Rotary knob.
Select the MMSI number input area then push the Rotary knob. Enter the MMSI.
3.3 Performance Check
Power the system and check the receiver and transmitter as follows:
Receiver
1. Set the unit as follows:
Speaker: ON, Squelch: OFF, AGC: Fast, Gain: Maximum
2. Confirm that a signal can be received on each band. If noise is present or a signal
is weak, check the antenna lead-in section, coaxial cable and ground.
Transmitter
1. On each band, confirm that the antenna is tuned when the 0/TUNE key is pressed.
If "tuning error" appears, check the antenna (connection, ground, etc.).
2. Communicate with the handset. Confirm that IA and IC change with voice level.
3.4 System Setup
This section shows you how to access the [SERVICE] menu, and enter the system
setting.
3.4.1 SERVICE menu
A password is required to access the [SERVICE] menu. For details of the [SERVICE]
menu, see the service manual of the FS-1575/2575/5075.
3.4.2 EQUIP TYPE menu
The system automatically detects the model name and displays the results, [FS-
1575], [FS-2575] or [FS-5075].
To Next Page
Loading...
