1. HOW TO INSTALL THE SYSTEM
1-11
Desktop installation, no keyboard fixture
1. Drill four mounting holes of 5 mm diameter, referring to the outline drawing at the
back of this manual.
2. Fix the unit with screws (M4, 4 pcs.) from under side of the desktop. (Supply the
screws locally. Make sure the screws are of a sufficient length for the thickness of
the desktop.)
Flush mount (option)
Use the optional flush mount kit (Type: FP03-09870, Code No.: 008-535-630) to
mount the sub control unit.
1. Prepare a hole in the mounting location referring to the outline drawing at the back
of this manual.
2. Set the unit to the hole.
3. Attach the mounting plate to the unit with four screws from the rear side.
4. Screw the wing screw to each mounting plate and then insert hex bolt to each wing
screw.
5. Fasten each wing screw and then fasten the hex nuts.
Name Type Code No. Qty
Mounting plate 03-163-7531 100-306-261 4
Hex nut M5 000-863-108 4
Wing screw M540 000-162-682-10 4
Pan head screw M412 000-163-192-10 4
Screw holes
Screw holes
To Next Page
Loading...
