1. HOW TO INSTALL THE SYSTEM
1-15
1.6 IF (Interface) Unit (FSV-8502)
Refer to the outline drawing at the back of this manual for mounting dimensions.
Fasten the unit with 520 self-tapping screws. If the unit is to be installed on a
bulkhead, be sure that the location does not allow water to drip into the cable entrance.
1.7 Junction Box (FSV-2550)
A junction box must be installed between the transceiver and the hull unit. Referring
to the outline drawings at the back of this manual for dimensions, install the junction
box on the hull unit stand where possible. Where installation on the hull unit stand is
not possible, install the junction box securely on a wall or bulkhead using M10 bolts (6
pcs., supplied). When installing the junction box to the hull unit, use M12 bolts (6 pcs.,
supplied).
1.8 Raise/Lower Control Box (FSV-2530)
Under normal installation circumstances, install a motion sensor to the raise/lower
control box.
When using the control box extension box (FSV-2560), remove the two fans from the
raise/lower control box and install them in the control box extension box. Install the
motion sensor in the control box extension box, then secure the control box extension
box to the hull unit.
1.8.1 How to install the motion sensor in the raise/lower control box
The motion sensor is package separately. Follow the procedure below to install the
motion sensor. When using a control box extension box, install the motion sensor
inside the control box extension box.
1. Remove the front cover of the raise/lower control box.
2. Remove the top board inside the raise/lower control box.
3. Insert the motion senor through the top of the raise/lower control box, then, using
the four screws inside the raise/lower control box, secure the sensor.
4. Connect the cable with the D-sub connector to the motion sensor socket, then
secure the cable with the two screws.
D-sub connector cableD-sub connector cable
Motion sensorMotion sensor
Screws
Screws
To Next Page
Loading...
