Gilat SkyEdge II VSAT modem
C-27
6. Go to the top of the page and press the Submit button and OK to save the new
settings.
The VSAT modem is now configured to be used with the FV-110.
C.7.2 ACU configuration
To set-up the ACU to work with a Gilat SkyEdge II VSAT modem, do as follows:
1. Add a modem profile with the Gilat SkyEdge II modem. See Modem profiles on
page 5-22.
2. Add a satellite profile using the Gilat SkyEdge II modem profile just created. See
Satellite profiles on page 5-24.
3. Edit the network settings and input the IP information supplied with the modem. See
To configure the LAN network on page 5-29.
4. Activate the satellite profile.
See also the configuration example in the following section.
Parameter Settings
RF Downlink
frequency
In the section General the RF Downlink frequency is shown. Write
it down as it is going to be used for the selection of LNB LO.
Further down on the page you find the BUC and LNB LO
frequencies.
LNB LO
Depending on the RF Downlink frequency select an appropriate
LNB LO of 9.75, 10.25, 10.75 or 11.25 GHz which will result in an
L-band frequency between 950 and 1650 MHz which is the
operating frequency band of the SkyEdge II Access modem.
BUC LO
Select the BUC to be 12.8 GHz as this is the BUC LO of the FV-110.
Remember to inform the hub operator about this when doing line up
and commissioning.
BUC 10MHz
Reference
Signal
The BUC 10MHz Reference Signal must be configured to ON,
otherwise the FV-110 will never allow TX. Scroll further down to
enable GPS for the Location Coordinates. This enables the serial
protocol of the modem so it can communicate with the ACU.
Table C-9: Configuration of Gilat SkyEdge II VSAT modem
To Next Page
Loading...