9. OTHER FUNCTIONS
9-5
9.4 How to Select Input, Output Data
Select the data to receive and output. Before selecting data to output, confirm what
data the external equipment requires. Output necessary data only. Outputting unnec-
essary data can cause receiving problems at the external equipment.
9.4.1 Input data
Open the [INTERFACE] menu and select [SELECT INPUT DEVICE].
Select the item to process then push the RotoKey
TM
. Do one of the following depend-
ing on your selection.
Item Options
[POSITION & SOG/COG] [Internal GPS]: Use the internal GPS navigator.
[Auto]: Select if you have multiple navigators connected
and you want to use them instead of the internal GPS
navigator. If the external source is a FURUNO make, its
name appears below [Auto]. Select it to have that device
feed respective data.
[DEPTH], [WATER TEM-
PERATURE] and [SPEED
THROUGH WATER]
[Auto]: Select when multiple external sources are avail-
able. In this case, the device with the lowest IP address
has priority. If the source is a FURUNO make, its name
appears be-low [Auto]. Select it to have that device feed
respective data.
Scroll
To Next Page
Loading...
