3. ADJUSTMENTS
3-16
3.5.5 Ethernet output setting
1. Press the MENU/ESC key to open the main menu.
2. Select [7 I/0] then [5 Ethernet].
3. Select [1 Sentence].
4. Press the cursorpad to select the sentence then press the NU/CU ENT key.
5. Press the cursorpad (W or X) to select the TX interval. TX interval is available in
[---], [0.1s]*, [0.2s]*, [1sec], [2sec], [3sec], [4sec], [5sec], [6sec], [10sec], [15sec],
[20sec], [30sec], [60sec] and [90sec].
*: Only for GGA, GLL, GNS, RMC and VTG.
Note: For the TX interval of [0.1s] or [0.2s], set the positioning cycle (Refer to Op-
erator’s Manual) as follows:
• For [0.1s], set the positioning cycle at 10Hz.
• For [0.2s], set the positioning cycle at 5Hz or 10Hz.
6. Press the NU/CU ENT key.
7. Press the MENU/ESC key.
8. Select [2 IP ADR/Port].
9. Enter the IP address and port (setting value: 49152 to 65535) for the output des-
tination with the numeric keys.When setting dual configuration (see section 3.7),
set "239.192.000.004" for IP address and "60004" for port.
10. Move the cursor to select [Enter] then press the NU/CU ENT key.
11. Press the MENU/ESC key to close the main menu.
To Next Page
Loading...
