5. ROUTES
5-10
5.13.5 How to adjust the size of the arrival notification area
The arrival notification area is a fixed-radius area around each route point and is
shown as a dotted red circle. The area is used to calculated the turning point towards
the next route point and also as an alert trigger. You can adjust the size (radius) of the
area.
1. From the [Home] screen, tap [Settings] => [Routes] => [Routes]. The route menu
options appear in the right-hand side of the screen.
2. At [Circle Radius] in the menu options, set the size of the area.
Drag the slider on the slide bar to change the size, or tap the keyboard icon, enter
a value, then tap [OK].
3. Tap the [x] at the top-right corner of the menu to close the menu.
5.13.6 How to enable/disable the arrival notification
When you approach the final point in a route, a pop up message appears to inform you
that the route is completed.
Note: If you set [Arriving at Destination] to [ON], in the [Notifications] menu, an audible
alert is also released when you reach the preset distance from the destination.
1. From the [Home] screen, tap [Settings] => [Routes] => [Routes]. The route menu
options appear in the right-hand side of the screen.
2. Tap the toggle box at [End Route Notification] to show [ON] or [OFF] as required.
3. Tap the [x] at the top-right corner of the menu to close the menu.
5.13.7 How to keep or discard a route destination once you arrive
By default, a route destination is kept after you arrive and the route remains active.
You can discard the destination and the route remains saved but becomes inactive.
1. From the [Home] screen, tap [Settings] => [Routes] => [Routes]. The route menu
options appear in the right-hand side of the screen.
2. Tap the toggle box at [Keep Destination] to show [ON] or [OFF] as required.
3. Tap the [x] at the top-right corner of the menu to close the menu.
Arrival
notification
area
To Next Page
Loading...
