10. NOTIFICATIONS
10-5
percentage, the notification is triggered. For [Waste Water] and [Black Water],
when the tank volume is above this percentage, the notification is triggered.
10.5 Wind Notifications
1. Open the [Notifications] menu then select [Wind].
2. Tap the toggle box to show [ON] for the notification(s) you want to set.
3. Drag the slide bar or tap the keyboard icon at the active notification to set the no-
tification parameters.
• [Max TWS]: When the wind speed exceeds this setting, the notification is trig-
gered.
• [Wind Shift]: When the wind shift exceeds than this setting, the notification is
triggered.
• [Low AWA]: When the port-side wind speed exceeds this setting, the notifica-
tion is triggered.
• [High AWA]: When the starboard-side wind speed exceeds this setting, the no-
tification is triggered.
10.6 Restoring Notification Defaults
You can restore the default settings for the [Notifications] menu at any time. This pro-
cedure does not affect any other settings.
Open the [Notifications] menu then tap [Factory Default Settings] => [Reset to Factory
Defaults]. A confirmation message appears. Tap [Yes] to restore the default settings,
or tap [No] to keep the current settings.
Note: This procedure only resets the [Notifications] menu settings. No other settings
are changed.
10.7 Notifications List
All notifications are stored in the [Notification and System Messages] list. When the
list is full, the oldest notification is deleted to make room for the newest. You can also
save the list to a microSD Card.
Tap to show the slide-out menu.
Drag the scrollbar to scroll the
page.
Tap a notification to save the
selected item on the SD card
(requires SD card insertion).
To Next Page
Loading...
