Furuno GP-3500 - Editing Routes; Inserting Waypoints; Removing Waypoints from Routes

6. ROUTE
6-5
6.2 Editing Routes
6.2.1 Inserting waypoints
Waypoints can be inserted in routes as follows:
1. Press the [MENU] key to show the main menu.
2. Press the [2] key to show the ROUTES LIST.
3. Rotate the [ENTER] knob to select the route in which you want to insert a
waypoint.
4. Press the [ENTER] knob three times to show the waypoints window.
5. Rotate the [ENTER] knob to place the red cursor at the location where you
want to insert a waypoint.
6. Roll the trackball in up-down direction to select the waypoint you want to
insert.
7. Press the [ENTER] knob.
Note: If a wrong waypoint is inserted, press the [CLEAR] key to delete.
8. Press the [MENU] key several times to close the menu.
6.2.2 Removing waypoints from routes
1. Press the [MENU] key to show the main menu.
2. Press the [2] key to show the ROUTES LIST.
3. Rotate the [ENTER] knob to select the route in which you want to remove a
waypoint.
4. Press the [ENTER] knob three times to show the waypoints window.
5. Rotate the [ENTER] knob to select the waypoint you want to remove.
6. Press the [CLEAR] key to remove the waypoint.
7. Press the [MENU] key several times to close the menu.