1. OPERATIONAL OVERVIEW
1-4
1.3 How to Adjust the Brilliance of the Display and
Panel
1. Press the BRILL key to show the following setting window.
2. To adjust the display brilliance, press the cursorpad (W or X) or the BRILL key
(setting range: 0 to 15, default: 14 for day mode/6 for night mode).
3. To adjust the panel brilliance, press the cursorpad (S or T) (setting range: 0 to
9, default: 7 for day and night modes).
4. Press the MENU ESC key to close the setting window.
Note 1: The default settings for night mode is 6 for [Display] and 7 for [Panel]. If the
display is difficult to see when switching to the night mode, press the cursorpad (X) to
increase the display brilliance.
Note 2: When you switch the brilliance mode, the last-used brilliance for the selected
mode is set.
Note 3: When the brilliance is preset, the background color is also preset (see
section 2.2). So both the brilliance and the background color are restored to the de-
fault when long-pressing the ENT key.
Switch the color mode between
day mode and night mode.
Long-press to restore the
settings to default of day mode.
To Next Page
Loading...