3. SETTINGS
3-13
3.8.3 How to select the input data
1. Press the MENU ESC key to open the main menu.
2. Select [5 I/O] then [6 Data
Source Select].
3. Select [1 HDG].
4. Select the port for heading data.
[1 Data1], [2 Data2], [4 Data4]: Use the heading
data received from the equipment connected to the
port 1 (or 2, 4). The heading data calculated from
the GS-1001 is not used. Go to step 7.
[5 Ethernet]: Use the heading data received from
the equipment connected via the LAN port. Go to
step 5.
[6 CAN]: Use the heading data calculated from the
GS-1001. The heading data received from the external equipment is not used. Go
to step 11.
5. Enter the Ethernet SFI with two alphabets and four figures. SFI (System Function
ID) is an identification code used by the system.
To enter "AB1234", for example, do as follows:
1) Use the cursorpad to select "A" then press the ENT key.
2) Use the cursorpad to select "B" then press the ENT key. The cursor moves to
"0".
3) Use the cursorpad (X) to select "1" then press the ENT key. Or press the 1
key.
4) Refer to step 3, enter "2", "3" and "4".
6. Move the cursor to [Enter] then press the ENT key. Go to step 11.
7. Select [1 HDG].
Backspace
To Next Page
Loading...