8. INSTALLATION
8-12
Fabrication
TTYCS-1
8.2.3 Antenna unit
Connection of the cable assembly “80-580-0008”
1. Connect the main cable and antenna cable to the cable assembly as shown in the
figure below.
Note: Do not use pliers to tighten caps, otherwise the caps may be damaged. Use
your fingers to tighten the connectors sufficiently. (0.39 to 0.49 N•m)
2. Wrap the cable assembly connectors with self-bonding tape and vinyl tape, for
waterproofing, as outlined in the procedure below.
1) Wrap the connectors with a single layer of vinyl tape, then wrap the connec-
tors with self-bonding tape.
2) Wrap two layers of vinyl tape over the self-bonding tape.
Arbitrary lengthArbitrary length
SheathSheath
Vinyl tapeVinyl tape
Vinyl tapeVinyl tape
Wind the shield.Wind the shield.
35 mm35 mm
100 mm100 mm
7 mm7 mm
Cable from antenna unitCable from antenna unit
ANT-DN18WAPVC-300/400/500
(Main cable)
ANT-DN18WAPVC-300/400/500
(Main cable)
80-580-0008
(Cable assembly)
80-580-0008
(Cable assembly)
←GS-1001←GS-1001
GS-1003→GS-1003→
Cable from antenna unit
80-580-0008
(Cable assembly)
80-580-0008
(Cable assembly)
ANT-DN18WAPVC-300/400/500
(Main cable)
ANT-DN18WAPVC-300/400/500
(Main cable)
ANT-DN18WAPVC-300/400/500
(Main cable)
ANT-DN18WAPVC-300/400/500
(Main cable)
Cable from antenna unitCable from antenna unit
80-580-0008
(Cable assembly)
80-580-0008
(Cable assembly)
To Next Page
Loading...