Furuno LS-6100 - Page 18

11
2. Use ▲ or ▼ to set the cursor where
desired. Picture advancement is
stopped until step 3 is completed.
3. Press the [MARK] key again. The
latitude and longitude position at the
cursor is output to the navigator and a
vertical line marks location. Further, the
display shows the waypoint name (next
sequential number) and position of the
location selected at step 2.
WAYPOINT
Name FREQ.
Lat : 34°22.796'N
Lon : 136°07.264'E
05
[MENU]: Exit
Erase?
Waypoint data display
Note: If you attempt to enter 13th
waypoint, the message “Memory full!”
appears. In this case, erase an
unwanted waypoint to enable entry.
4. Press the [MENU/ESC] key to save the
waypoint under the name shown, or go
to step 5 to change its name.
5. Press ► to open the waypoint name
entry window.
WAYPOINT
Name FREQ.
Lat : 34°22.796'N
Lon : 136°07.264'E
05
[MENU]: Exit
01
------
ENT
Erase?
Waypoint window, name entry
6. Use ▲ or ▼ to set character; ◄ or ► to
shift cursor. The name may consist of
eight alphanumeric characters.
Note: Character order is
0→1…9→A→B…Z→0…
7. Press ► to choose ENT.
8. Press the [MENU/ESC] key to register
the waypoint.
Registering waypoint from the
waypoint list
1. Press the [MENU/ESC] key to open the
menu.
2. Use ▲ or ▼ to choose WAYPOINT
LIST from page 2 of the menu.
3. Press ►.
WAYPOINT LIST
0101
0203
03
------
------
------
------
------
------
------
------
------
[MENU]: Exit
Waypoint list
4. Choose an empty waypoint and press
►. Press ► again.
NEW WAYPOINT
Name FREQ.
Lat : 34°22.796'N
Lon : 136°07.264'E
05
[MENU]: Exit
04
------
ENT
Erase?
New waypoint window, name entry
5. Use ▲ or ▼ to set character; ◄ or ► to
shift cursor.
6. Press ► to select ENT.
7. Enter latitude and longitude, similar to
how you entered waypoint name
8. Press the [MENU/ESC] key to register
the waypoint.
Setting destination waypoint
Set a destination waypoint to find range,
bearing and time-to-go to that point. You
can see range and bearing to a waypoint.
Time-to-go is shown on the Time to Go
digital display.
1. Press the [MENU/ESC] key to open the
menu.