Furuno NAVNET TZ2 TZTL12F - How to Follow a Route Selected from the Routes List

5. ROUTES
5-14
The following occurs:
• The color of the route becomes purple, and arrows on the route point in the direction
in which to follow the route.
• The Goto point (1st route point) is highlighted.
• A solid purple line with arrows connects between current position and the points on
the route. This line indicates the set course. A solid yellow line runs between runs
between current position and the destination. This line shows the shortest distance
to the destination.
• Points are switch according the waypoint switching mode set on the menu. To se-
lect the mode, go to the Home screen, then tap [Settings]→[Routes]→ [WPT Switch
Mode]. Select [Circle and Cross Line], [Circle], or [Cross Line] as appropriate.
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines and set their width with [Display XTE Lines] and [XTE Value] re-
spectively in [Routes] menu.
Note: If you want to be notified when you reach a Goto point, turn on [Waypoint Cross-
ing Notification] on [Routes] of the menu (see subsection 5.11.8). Then the message
"Waypoint Crossing" appears when you reach a Goto point. For the arrival timing, see
section 5.11.5.
5.10.2 How to follow a route selected from the Routes list
1. Go to the Home screen, then tap [Lists]→[Routes].
2. Tap the route to follow then tap [Goto].
The following occurs:
• The line for the selected route turns red.
• The go to point (1st route point) is highlighted.
• A thick red dashed line and a yellow line run between the current position and the
1st route point of the selected route. The thick red dashed line is the course to follow
to get to the 1st route point. The yellow line is the shortest course from the current
position to the go to point.
• The go to point is numbered "1". The starting point is indicated in the pop-up menu
item[Details] as [Start].
• The arrival area marker appears if activated on the menu (see section 5.11.5).
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines and set their width with [Display XTE Lines] and [XTE Value] re-
spectively in [Routes] menu.
Note: If you want to be notified when you reach a goto point, turn on [Waypoint Cross-
ing Notification] in the [Routes] menu (see subsection 5.11.8). Then the message
"Waypoint Crossing" appears when you reach a goto point. For the arrival timing, see
section 5.11.5.