EasyManua.ls Logo

Furuno NAVNET TZ2 TZTL12F - Page 368

Furuno NAVNET TZ2 TZTL12F
420 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15. OTHER FUNCTIONS
15-7
[Graphic Instruments Setup] - [PROPULSION ENGINE/OTHER ENGINE]
[Graphic Instruments Setup] - [CZONE SETUP]
[YAMAHA ENGINE SETUP] menu
See the Installation Manual.
[HOME PAGE] section
[IF-NMEAFI SETUP] section
Menu Item Description Options (setting range)
[Max. RPM] Set the maximum rpm of your engine to
show on the RPM display.
1 to 20,000 rpm
[Red Zone Oil Pressure] Set the starting value for the red zone area
of the oil pressure meter.
0 to 998 kPa
[Max. Oil Pressure] Set the maximum oil pressure of your
engine.
1 to 999 kPa
[Min. Temperature] Set the minimum temperature for your
engine.
32.0 to 210.0°F
[Red Zone Temperature] Set the starting value for the red zone area
of the engine temperature indicator.
32.0 to 999.9°F
Menu item Description
[Add Default CZone
Pages]
Create, edit C-Zone pages.
[CZone DIP Switch
Settings]
Set this unit’s DIP switches. For the serviceman. Do not change the set-
tings.
Menu item Description
[Reset Instrument Pages] Restore all instrument pages.
[Reset Default Settings] Restore default settings for the [Graphic Instruments Setup] menu.
Menu item Description Options (setting range)
[Factory] Restore home page default settings.
Menu item Description Options (setting range)
[Select IF] Select [IF-NMEAFI] to set the analog data that is input from the IF-NMEAFI.
[Category] Select the category for the analog sensor to
set.
[Wind], [ST800_850], [Fuel],
[FreshWater], [WasteWater],
[LiveWell], [Oil], [BlackWater]
[Resistance Full] The resistance, in Ohms, when the tank is full. 0 (ohm) to 300 (Ohm)
[Resistance Mid] The resistance, in Ohms, when the tank is half
full.
0 (ohm) to 300 (Ohm)
[Resistance Empty] The resistance, in Ohms, when the tank is
empty.
0 (ohm) to 300 (Ohm)
[Capacity] The capacity of the tank. 0 (G) to 2650 (G)
[Fluid Instance] Set the tank’s NMEA2000 instance number. 0 to 5
[Self test] Test results are displayed.
[Set Hardware To
Factory Default]
Resets the converter selected at
[Select IF] to factory default.
[OK], [Cancel]

Table of Contents

Related product manuals