15. OTHER FUNCTIONS
15-8
[DATA ACQUISITION] section
[NMEA 2000 Log] menu
[INTERNAL GPS SETUP] section (TZTL12F/TZTL15F only)
[SC-30 SETUP] section
[NETWORK SENSOR SETUP] section
The [NETWORK SENSOR SETUP] section allows you to set up compatible FURUNO
NMEA2000 sensors. Calibrations and offsets applied in this menu are also applied to
the sensor itself.
Tap the sensor to access its menus and settings. For details regarding the menu struc-
ture and set up of each sensor, see the appropriate operator’s manual, supplied with
the sensor.
Menu Item Description Options (setting range)
[GP330B WAAS Mode] Select [ON] to use the WAAS mode for the
corresponding GPS antenna.
[OFF], [ON]
[WS-200 WAAS Mode]
[Data Source] Select the source for each data to input to the system. If two or more
sources are connected for a data, select one using the pull-down dialog
box. (FURUNO sensors are shown at the upper part of the list.)
[Sensor List] Show the information for sensors connected to your equipment. Also,
you can set a "Nickname" for them here.
[NMEA0183 Output] Select [ON] to output NMEA sentences.
[NMEA 2000 PGN Output] Select [ON] for the PGNs (Parameter Group Number, CAN bus
(NMEA2000) message) to output from the CAN bus port.
[Sky View] Show the condition of GPS and GEO (WAAS) satellites
on the [GPS SkyView] display. The bearing and eleva-
tion angle of all GPS and GEO satellites (if applicable) in
view of your receiver appear. For the serviceman.
Note: The [GPS SkyView] display can also be shown by
tapping the GPS icon (shown right) on the home screen.
Menu item Description Options (setting range)
[Enable NMEA
2000 Log]
Enable or disable saving of NMEA2000 data. [OFF], [ON]
[NMEA2000 Log
Storage Location]
Select where to save NMEA2000 data.
Menu Item Description
[WAAS Mode] Set to [OFF] when using external GPS.
Menu item Description Options (setting range)
[WAAS Mode] Select [ON] to use the WAAS mode. [OFF], [ON]
[Heading Offset] Enter the offset value for heading. -180° to +180°
[Pitch Offset] Enter the offset value for pitching. -90° to +90°
[Roll Offset] Enter the offset value for rolling. -90° to +90°
To Next Page
Loading...
