Furuno NAVNET TZ2 TZTL12F - How to Manage Your Charts; How to View Your Charts

15. OTHER FUNCTIONS
15-12
15.6 How to Manage Your Charts
The NavNet TZtouch2 uses the Mapmedia charts. There are two types of charts: free
and paid. When using paid charts, an unlock code is required. To share the system ID
and unlock code in the NavNet TZtouch2 network, open the home screen, then tap
[Settings][Initial Setup][ON] for [Chart Master Device] of one NavNet TZtouch2.
The NavNet TZtouch2 uses the same Mapmedia charts as NavNet 3D. Even though
NavNet TZtouch2 is a master-less system in networking, for charts one NavNet
TZtouch2 unit should be set as Chart Master to share the System ID, which will be
necessary to obtain a chart unlock code from Mapmedia.
Note: When two or more NavNet TZtouch2 share an unlock code, you need to get an
unlock code again if changing the setting of [Chart Master Device]. For example, if the
NavNet TZtouch2 that was used as the “primary” ([Chart Master Device] setting: [ON])
is used as the “secondary” ([Chart Master Device] setting: [OFF]) (and vice versa), the
unlock code must be reacquired. Is required. For details, see “Chart is not displayed
after changing chart master settings.” on page 16-4.
15.6.1 How to view your charts
Tap the Home icon to show the home screen, then tap [Charts] to display your charts
catalog.
System ID
display
Tap to enter
unlock code
Chart manufacturer
Chart file name Chart file type
See table
below.
Tap to show [FIlter
charts] pop-up menu.
Tap to dowload chart
unlock codes.
Chart version no. Trash icon