Furuno NAVnet TZtouch2 - How to Move a Point; How to Move a Point on the Screen

4. POINTS, BOUNDARIES
4-11
3. To change the position, tap [Edit Pos] to display the software keyboard. Set the
position referring to the instructions in step 2.
4. Tap [Color] to change the color of the point symbol.
5. Tap [Symbol] to change the point symbol.
6. Tap [Comment] to enter a comment, with the software keyboard.
7. Tap [] to confirm.
4.8 How to Move a Point
You can move a point by two methods, on the screen and from the points list.
4.8.1 How to move a point on the screen
1. Tap the point to move, then select [Move] from the pop-up menu. The
icon shown right is put on the point.
2. Drag and drop the point to its new location.
3. Tap [End Move] at the top right-hand corner of the screen to finish.
Note 1: If [Move Tool on Long Push] is set to ON (in the [Settings]-[General] menu, a
point can be moved by long-pushing on the point for three seconds.
Note 2: A point can be moved to the position you specify. Tap the point and [Edit Pos],
then enter the position from the keyboard.
Switch latitude and
longitude coordinates.
Tap
Position display format
Select position display format
from pull-down menu.