12. INSTRUMENT-RELATED DISPLAYS
12-13
3. Do one of the following depending on your objective:
• Bring to front: If two indications are occupying the same location, you can se-
lect one to bring to the front. Tap the indication to bring to the front, then tap
[Bring to Front].
• Remove the indication: Tap [Remove].
• Change the indication: Tap required data in the [NAVIGATION DATA],
[ROUTE INFORMATION], or [WIND AND WEATHER].
• Change the indication type: Tap [Change Type] to show the [Edit Instrument]
pop-up menu, shown on the next page.
[GRAPHIC] changes the size of a graphic indication or changes a numeric indi-
cation to the corresponding graphic indication.
[NUMERIC] changes the size of a numeric indication or changes a graphic in-
dication to the corresponding numeric indication.
[HISTORICAL GRAPH]**: displays the selected data in a graph.
[TANK]: sets the size of the tank indication.
[HIGHWAY], [NAVPILOT]* select respective display size.
*: Requires connection of a FURUNO NAVpilot.
**: Tank/engine data is not displayable as a graph.
• Change the graph’s plotting period and range: Tap [Plot Period] to change
the time over which the graph’s data is plotted (x axis). Tap [Plot Range Value]
to change the range for the data display in the graph (y axis).
Note: Depending on the range and period selected, some data may be dis-
played with steep peaks and troughs when converted into graph format.
To Next Page
Loading...
