15. OTHER FUNCTIONS
15-8
NETWORK SENSOR SETUP section
The [NETWORK SENSOR SETUP] section allows you to set up compatible FURUNO
NMEA2000 sensors. Calibrations and offsets applied in this menu are also applied to
the sensor itself.
Tap the sensor to access its menus and settings. For details regarding the menu struc-
ture and set up of each sensor, see the appropriate operator’s manual, supplied with
the sensor.
CALIBRATION section
DATA DAMPING section
FUSION section
BROWSER INSTALLATION section
Menu item Description Options (setting range)
[Heading] Offset heading data. -180.0° to +180.0°
[Speed Through
Water]
Calibrate speed data. Enter amount in percentage. -50° to +50°
[Wind Speed] Offset wind speed data. Enter amount in percentage. -50° to +50°
[Wind Angle] Offset wind angle data. -180.0° to +180.0°
[Sea Surface
Temperature]
Offset sea surface temperature data. -10° to +10°
Menu item Description Options (setting range)
[COG & SOG] Set data damping time. The lower the set-
ting the faster the response to change.
0 to 59 seconds
[Heading]
[Speed Through Water]
[Wind Speed&Angle]
[Rate of Turn]
Menu item Description Options (setting range)
[Connect to Fu-
sion]
Connect to your Fusion equipment.
[Fusion Auto
Volume]
Set to [ON] to allow this unit to control the Fusion volume.
[Minimum
Speed]
Set the minimum speed threshold. Exceeding this
speed activates volume auto control.
0.0 kn to 19.9 kn
[Maximum
Speed]
Set the maximum speed threshold. 0.1 kn to 99.0 kn
[Volume In-
crease]
Set the amount of extra volume to output. 10% to +50%
Menu item Description Option (setting range)
[FAX30 Browser] Show the Facsimile Receiver FAX-30 display.
[FA30 Browser] Show the AIS Receiver FA-30 display.
[FA50 Browser] Show the AIS Receiver FA-50 display.
To Next Page
Loading...
