Furuno NAVnet TZtouch2 - Page 347

APPENDIX 1 MENU TREE
AP-8
Alarm
Hardware Alarm (ON, OFF)
Cross Track Error Alarm (ON, OFF)
Depth Alarm (ON, OFF)
Depth Alarm Value (0 - 900(ft), 30)
Sea Surface Temperature Alarm (Off, Over, Under, Within, Out of)
Temperature Alarm Value (32 - 140(
qF
), 70.00)
Temp. Alarm Range Min Value (15 - 160(
qF
), 60.0)
Temp. Alarm Range Max Value (15 - 160(
qF
),70.0)
Temp. Shear Alarm Value (0 - 15(
qF
), 1.0)
Speed Alarm (Off, Over, Under)
Speed Alarm Value (0 - 99.9(kn), 10.0)
Anchor Watch Alarm (ON, OFF)
Anchor Watch Alarm Value (1 - 3300(ft), 150)
Wind Speed Alarm (Off, Apparent, True)
Wind Speed Alarm Value (0.0 to 99.9; 10 kn)
Own Ship Alarm Zone (OFF, ON)
Own Ship Alarm Zone Warning (1 to 5000; 300 m)
Low Fuel Alarm (ON, OFF)
Low Fuel Alarm Level (10-50%; 20%)
Notification Sound (ON, OFF)
Notify when NAVpilot is engaged (ON, OFF)
Alarm Sound (ON, OFF)
Sound Alarm Until Acknowledged (ON, OFF)
Save Log File (Save log file to micro SD card.)
Reset Default Settings
1
2
1
Continued from previous page
Fish Finder Alarms
Initial Setup
Fish Alarm (OFF, Single Beam, Triple Beam)
Range Minimum Value (0~1200; 0m)*
Range Maximum Value (0~1200; 10m)*
Fish Alarm Level (Low, Medium, High)*
Transducer Draft (0~99.9; 0)
Salt Water (OFF, ON)
Transducer Setup (Show the menu for setting up the transducer)
Transmission Power Auto (OFF, ON)
Transmission Power (0~10; 10)
External KP (OFF, ON)
Bottom Level (-40~40; 0)
Auto Gain Offset (Multi-Sounder) (-5~5; 0)
Auto Gain Offset (Side Scan) (-5~5; 0)
Auto Gain Offset (Cross Section) (-5~5; 0)
STC (Side Scan) (0~10; 5)
STC (Multi-Sounder) (0~10; 5)
TX Pulse (Short1, Short2, Standard, Long)
DFF-3D Monitoring
Set Hardware to Factory Default
Reset Default Settings
*: Settings have no effect when
Fish Alarm is set to OFF.