Furuno NAVpilot-300 - 1.5 Steering Modes Overview

1. INTRODUCTION
1-6
1.5 Steering Modes Overview
The NAVpilot-300 has following steering modes:
The displayed contents for each mode are divided into two main areas: the graphics
area and the data box area. The top section of the screen shows indications for the
steering mode currently in use and equipment status.
For details on each turn mode, see chapter 2.
The figure below shows an example of the autopilot main screen, for reference.
1.5.1 Graphic area
The contents of the graphic area change, depending on the steering mode in use.
• Standby (STBY)
• Navigation (NAV)
• Safe Helm
•
Autopilot (AUTO)
• Override (OVRD)
• NFU (Non Follow Up)
• FishHunter
™
• Turn
• Dodge
Steering mode Displayed contents/Function
Standby Compass or digital display. Toggle between compass and digital
displays is only available while the system is in standby mode.
See section 1.5.2.
Autopilot, Override,
NFU, Dodge
Data is display in the format selected during standby (digital or
compass).
Navigation Data is display in the format selected during standby, however, if
compass is selected, the Highway display is shown.
Turn Display contents are dependent on the turn mode in use. See
section 2.4.1.
FishHunter
™
Display contents are dependent on the FishHunter
™
mode in
use. See section 2.5.1.
Safe Helm Display contents are dependent on the mode at recovery. See
AUTO mode and NAV mode above.
Steering mode indication
Status indications
Graphic area
Data box area
: Keylock active
: Alert active
: Power Assist active
: Simulation active
ABIKI
: Standby mode
: AUTO mode
: DODGE mode
: Non-Follow-Up mode
: Override mode
: AUTO Advanced mode
: NAV mode (Precision)
: NAV mode (Economy)
: SABIKI™ mode