Furuno NAVpilot-300 - 2.8 OVRD Mode for EVC Systems

2. STEERING MODES
2-21
2.8 OVRD mode (only for EVC system)
When the EVC system controls the rudder, the OVRD (override) mode is automatically
enabled. The autopilot can not control the boat in the OVRD mode.
Note: The OVRD mode is enabled when [BOAT TYPE] is set to [EVCS-Pod Drive],
[EVCS-Outboard], [EVCS-Inboard] or [EVCS-In/Out].
2.8.1 OVRD mode activation in STBY mode
When the OVRD mode activates in the STBY mode, [OVRD] appears at the top-left
position of the display. At this time only the menus are operative. When the EVC sys-
tem releases control of the rudder, the autopilot goes to the STBY mode.
Note: For systems with SEASTAR SOLUTIONS OPTIMUS connected, a five second
countdown message appears when OVRD mode is deactivated. When the countdown
completes, the system automatically switches to STBY mode.
2.8.2 OVRD mode activation in the AUTO or NAV mode
For VOLVO IPS, YAMAHA HM or YANMAR VC10 EVCS configurations
When the OVRD mode activates in AUTO or NAV mode, the audio alarm sounds, the
pop-up message "EVC OVERRIDE" appears, and the mode indication at the top-left
position of the display shows [OVRD]. Press any key to stop the alarm and erase the
pop-up. When the EVC system releases control of the rudder, the autopilot goes to
STBY mode.
EVC Override is active. EVC Override is released.
359°
HDG
T
N
30
60
330
300
359°
HDG
T
COG
COG
COG
COG
EVC system releases
control of the rudder.
Press any key.
359°
HDG
T
359°
HDG
T
N
30
60
330
300
359°
HDG
T
COG
COG
COG
COG
COG
COG
EVC Override