1. INSTALLATION OF UNITS
1-4
1.3 Rudder Reference Unit FAP-6112
• Leave sufficient space around all moving parts.
• The unit must be coupled to the rudder as shown below, where the following conditions
are satisfied:
Use four self-tapping screws (supplied) to fasten the rudder reference unit.
350 mm <Y2 < 540 mm
X1 = X2
Y1 = Y2
X1
X2
Y1
Y2
90
Top view
Arrow mark
Note: The arm of rudder reference unit should be aligned with the arrow mark. Align the
notch on the shaft to the arrow mark if the arm is removed.
To Next Page
Loading...
