Furuno NAVpilot-611 - Wiring; Wiring System Overview

2-1
2. WIRING
2.1 Wiring System
All units are connected to the processor unit. The cables should be separated as far as
possible from cables carrying radio frequency or pulsed signals. At least one meter
separation is recommended.
Reversible pump
Solenoid valve
Hydraulic
linear drive
Power supply
12-24 VDC
Terminator MJ-A7SPF0011*
(supplied)
MJ-A7SPF0010-
100C (supplied)/
150C (option)/
200C (option)
MJ-A7SPF0012-100C
Control unit
FAP-6011
Processor unit FAP-5002
Terminator MJ-A7SPF0011*
(supplied)
MJ-A7SPF0010-100
PG-500
Rudder
reference
indicator
FAP-6112
Remote
controller
or
Distributor
Remote
controller
or
Distributor
PC
NMEA OUT
(FI-30 etc.)
NMEA IN
(FI-30 etc.)
NMEA IN/OUT
(FI-30 etc.)
*Attach the terminator to the empty connector of the last control unit in the series.
Wiring