1-1
1. INSTALLATION OF UNITS
1.1 Control Unit FAP-6011
The display unit can be installed two ways: surface mount and flush mount (optional kit
required). This section covers surface mounting. For flush mounting, see the flush mounting
instructions, issued separately. Use the supplied display hard cover when the system is not
in use.
Control unit FAP-6011
When selecting a mounting location for the control unit, keep the following in mind.
• The mounting location should be well ventilated.
• Mount the unit where shock and vibration are minimal.
• Do not mount the display unit under “Plexiglas” or any other type of shielding which could
trap heat and moisture or magnify sunlight energy onto the surface of the display.
• For maintenance and checking purposes, leave sufficient space at the sides and rear of
the unit and leave slack in cables.
• A magnetic compass will be affected if the control unit is placed too close to the magnetic
compass. Observe the compass safe distances to prevent disturbance to the magnetic
compass shown on page i.
To Next Page
Loading...
