3. INITIAL SETTINGS
3-15
3.5.2 Dockside setup for Fantum Feedback
TM
How to set the drive unit
1. Use the knob to select [DRIVE UNIT SELECTION] then push the knob.
2. Rotate the knob to select [REVERSIVLE 24V] or [REVERSIBLE 12V] then push the
knob.
Air bleeding
Note: Air bleeding can not be performed if the drive unit has not been selected.
1. Go back to the [DOCKSIDE STUP] menu.
2. Rotate the knob to select [AIR BLEEDING] then push the knob.
3. The cursor is selecting [NO]; push the knob. Rotate the knob to select [YES] then
push the knob to show the following message.
4. Press the W (or X) key until the indicator is completely filled (in black).
5. Remove the appropriate rubber cap of the cylinder to bleed air.
6. Press the W (or X) key until the indicator is completely filled (in black).
7. Remove the appropriate rubber cap of the cylinder to bleed air.
8. Repeat steps 4-7 to bleed air completely.
DOCKSIDE SETUP
DRIVE UNIT SELECTION: UNKNOWN
AIR BLEEDING: NO
RUDDER TEST: NO
AIR BLEEDING
AIR BLEEDING: NO
AIR BLEEDING
PUSH ARROW KEYS TO ENABLE
PUMPSET
PUSH MENU KEY WHEN DONE
To Next Page
Loading...
