3. INITIAL SETTINGS
3-37
3.17 RC (Remote Controller) SETUP Menu
Note: The [RC SETUP] menu is not shown in case of Fantum Feedback
TM
.
Set the type of remote controller you have as follows
1. The setting for [REMOTE CONTROLLER 1] is selected; push the knob.
2. Rotate the knob to select the type of remote controller connected.
[NFU]: Select for button- or lever-type remote controller.
[FU]: Select for dial-type remote controller.
[DODGE]: Select for dodge-type remote controller.
[DISABLE]: Disable remote controller operation.
3. Set the type for remote controller 2, if connected.
4. Press the X key to show the [ALARM SETUP] menu. For how to set this menu, see
Chapter 3 in the Operator’s Manual.
5. After reviewing the [ALARM SETUP menu], press the X key to show the following
message.
6. Press the X key to save all settings. To recheck your settings, press the W key. This
concludes the initial settings.
3.18 All Clear
The all clear feature restores all default settings. Open the [INSTALLATION] and [SYS-
TEM SETUP] menus. Select [ALL CLEAR] and [YES] to restore all default settings.
RC SETUP
REMOTE CONTROLLER1:
DISABLE
REMOTE CONTROLLER2:
DISABLE
NFU
FU
DODGE
DISABLE
SETTINGS ARE REGISTERED
AS ENGINEER SETTINGS
ARE YOU SURE?
PREV
YES NO MENU
To Next Page
Loading...
