Furuno NAVpilot-700 - How to Select Displays from the Menu

1. INTRODUCTION
1-12
1.4.4 How to select displays from the menu
You can select the nav data or graphic display to show in the STBY, AUTO(WIND)
and NAV(FISH HUNTER) modes.
1. Open the [SYSTEM SETUP] menu, select [DISPLAY DATA SELECT MENU] then
push the Course control knob.
2. Rotate the Course control knob to select the mode desired then push the knob.
Rotate the knob to select the display division desired then push the knob. The ex-
ample below shows the display divisions and default data in the STBY, AUTO and
NAV modes.
DISPLAY DATA SELECT MENU
STBY
AUTO
NAV
WIND*
* Visible when [SHIP’S CHARACTERISTICS]=sailboat
Navpilot-700
STBY, AUTO, NAV[1]*
1
STBY, AUTO, NAV[2]*
1 2
STBY, AUTO, NAV[3]*
1
2
STBY, AUTO, NAV[4]*
1
1: RUDDER 1: RUDDER
2: POS
1: POS
2: COG
1: COMPASS
STBY, AUTO, NAV[2]*
1
STBY, AUTO, NAV[3]*
1 2
STBY, AUTO, NAV[5]*
1
STBY, AUTO, NAV[4]*
1 2
Navpilot-711, 72
0
1: RUDDER 1: RUDDER
2: POS
1: POS
2: COG
1: COMPASS
* “WIND” available when [SHIP’S CHARACTERISTICS]=sailboat
Note: The number of boxes depends on setting of DATA BOX FORMAT in the
DISPLAY SETUP menu in the INSTALLATION menu.
[3] of 700: Two (default) or three boxes are available.
[4] of 711, 720: One or two boxes (default) are available.