5. MAINTENANCE, TROUBLESHOOTING
5-10
0011 "BYPASS/CLUTCH IS SHORT-
ED OUT"
Bypass/clutch is shorted. Turn off power.
0013 "RUDDER DRIVE ERROR" Turn off power.
0017 "RUDDER ANGLE ERROR" Turn off power.
0301 "COMMUNICATION ERROR" No communication between processor
unit and all control units. Turn off power.
Notice
2001 "INPUT VOLTAGE IS UNDER
LIMIT"
Input voltage under limit. Check power
supply.
2003 "INPUT VOLTAGE IS OVER
LIMIT"
Input voltage over limit. Check power sup-
ply.
2101 "NAV MODE PARAMETER ER-
ROR"
Invalid parameter entered in NAV mode.
Reenter parameter.
2105 "START TO TURN BY FISHING
MODE"
Boat is starting to turn after dodge opera-
tion.
2107 "CIRCLE MODE STOPPED" Circle mode was stopped.
2109 “MODE WAS CHANGED” Steering mode changed.
2201 "WARNING. REMOTE CON-
TROLLER’S SW IS ON"
Remote controller switch is ON. Turn it
OFF to continue operation.
2203 "THE PRESET TIME SET HAS
PASSED"
Watch alarm has activated.
2301 "HEADING SOURCE ARE
CHANGED"
Heading source changed.
2303 "WIND SOURCE ARE
CHANGED"
Wind source changed.
2305 "POSITION SOURCE ARE
CHANGED"
Position source changed.
2307 “SPEED SOURCE HAS
CHANGED”
Source of speed changed.
2330 "ARRIVED AT LAST WAY-
POINT"
Arrival alarm alerts you to arrival at final
waypoint.
2340 "WAYPOINT WAS CHANGED" Switching to next waypoint.
2360 "NO WATER TEMP DATA" Check water temperature sensor.
2362 "NO DEPTH DATA" Check depth sensor.
2370 “HELM SENSOR ERROR” Check helm sensor.
2901 "NO COMPASS ADJUSTMENT
DATA"
Check heading sensor.
Error
no.
Error message Meaning, remedy
To Next Page
Loading...
