Overview
2-2
3. Setup Guide
Configure the setting according to the needs of each user.
This NX-700A/B receives NAVTEX messages in the default setting as it is. Basically,
the NAVTEX, System, Display and Service menus are to be set by users. Do not attempt
to change the settings of the Initialize1 and Initialize2 menus needlessly.
If they have to be changed, do it after understanding the functions of them.
Table 2.2 User Setup Guide
Menu Item Setting Remarks Page
INS
Mask Mode
Manul
Select “INS” to set the Rcv Mask by
sentences from the INS.
2-8
Off
Auto Rcv Mask
On
Normally ON
Setting to enable the Auto mode
2-9
490kHz
Local Channel
4209.5kHz
Selection of receiving frequency 2-10
Rcv Mask
Station : A-Z
Message: A-Z
Setting of stations and message types.
The default setting is “Select All”.
2-10
INS Output
Mask
Station : A-Z
Message: A-Z
The default setting is “Select All”.
Selection of stations and messages to be
outputted to the INS.
2-11
NAVTEX
Ver-02.01
Printer Mask
Station : A-Z
Message: A-Z
Setting of printer output 2-12
INS
Auto
Receiver Mode
Manul
Normally “Auto”
When “Auto” is selected, the Auto mode is
enabled.
2-13
490kHz
Local Channel
4209.5kHz
Selection of receiving frequency 2-14
Off
All
Auto Print
User Select
Setting of printer output when a message is
received.
2-14
Rcv Station &
Msg
Station : A-Z
Message: A-Z
Setting of stations and message types.
The default setting is “Select All”.
2-15
NAVTEX
Ver-01.02
User Select
Station & Msg
Station : A-Z
Message: A-Z
Setting of sorting items of station and
message type in “User Select Message” on
the [LIST] menu.
2-15
Off
Warn Msg Alm
On
Setting of ON/OFF of alarm beep
when a message A, B or L is received.
2-16
Off
Int’l
Signal Monitor
Local
Selection of the frequency to be monitored. 2-17
Off
Key Beep
On
ON/OFF of Key beep setting 2-17
System
Cont’d
Time Offset
+ 00:00
Time difference of time display setting 2-18
Cont’d
To Next Page
Loading...
