Furuno RC-1800T - Printer (PP-520)

1. INSTALLATION
1-7
4) Set the transceiver unit such that the cable entrance of the transceiver unit
faces to the right, then set the transceiver unit to the console.
5) Put the transceiver unit on the fixing plates (right and left), then push the trans-
ceiver unit into the console until the unit contacts the stoppers.
6) Fasten the transceiver unit to the fixing plates with two M5 screws removed at
step 3). For the fixing locations, see the outline drawings of FS-1575T or FS-
2575T.
1.5 Printer (PP-520)
Fasten the printer PP-520 after the installation of the other equipment is completed.
For how to fasten the printer, see the outline drawing at the back of this manual and
the operator’s manual of the printer. Observe the compass safe distances in the
"SAFETY INSTRUCTIONS" on page i to prevent interference to a magnetic compass.
Extract the power cables and signal cables to be connected to the printer from the
grommet on the top cover. Attach the fixtures (supplied in the installation materials of
PP-520) to the top cover. Connect the cables to the printer. Adjust the size of the exit
for cables on the grommet then reattach the grommet.
Stopper (2 pcs.)Stopper (2 pcs.)
Fixing plate (right
and left)
Fixing plate (right
and left)
Cable entrance side
Transceiver UnitTransceiver Unit
M5 ScrewM5 Screw
Printer