1. INSTALLATION
1-10
3. Fasten the light from the top with the screws removed at step 1.
1.11.2 Charger Unit (BC-6158-SS/6200)
Fasten the charger unit (option) considering the following points.
• Select a location where vibration is minimal.
• The location should be moderate and stable in both temperature and humidity.
• The installation location must be able to support the weight of the unit.
• The location must be at least seven meters from a magnetic compass.
1. Remove four screws on the front panel then
remove the front panel.
2. Unfasten the screws fixing the charger unit. Pull the unit forward with the handle.
3. Fasten the case of the charger unit
from the top of rail with four screws
(M6u15 or longer, local supply).
4. Push the charger unit in until it contacts the stoppers. Fasten the unit to the rail
with the two screws prefastened to the rail, at the cutout location.
5. Attach the front panel.
Charger Unit (Front view)
Front panelFront panel
Four screws
Charger Unit
Pull forward.
Handle
Two screws to unfasten
(right and left)
Two screws to unfasten
(right and left)
Fixing holes
(4 places, right
and left)
Rail
Fasten at the cutout of the
charger unit (two places,
right and left).
Fasten at the cutout of the
charger unit (two places,
right and left).
To Next Page
Loading...
