Furuno RC-1800T - Setting [F6]: System; Setting [F3]-6: Manual Reception

2.1 MF/HF (150/250W) system
2-17
3) Setting [F6]: System
1. Press [F6] key to open “System” menu.
2. Place the cursor on “Change”, and then put it down to the item to be set.
3. Set the following items and press [Enter] key.
- MIF Tune OFF
- Freeze OFF
- AGC OFF FS-2550/1562 : OFF
FS-5000 : ON or OFF
- Emission ON
- Tx/Rx MSG Save ON or OFF : customer requests
- Edit before sending ON or OFF : customer requests
4) Setting [F3]-6: Manual Reception
In “AUTO” mode, the reception mode (ARQ or FEC) is set automatically according to
the receiving signal. If a mode other than “AUTO” is selected, receptions only in the
selected mode are activated.
1. Press [F3] and [6] keys to open “Manual Reception” menu.
2. Place the cursor on “AUTO” and press [Enter] key.
Fig.2.1.9
Manual Reception
AUTO ARQ FEC DIRC