5.1 Check list
5-3
5.1.3 Check list for each unit
Table 5.1.3
Check items Results
FS-2550/1562
System setting
The necessary system setting has been made?
The system setting channel “9928: Priority” is set to “1:
Remote”?
Method of system setting
• FS-2550: [CH] + Power ON
→
Select “9999”
→
Enter
“75”
→
”Set”
• FS-1562: [RCL] + Power ON
→
Select “9999”
→
Enter
“1562”
→
”Set
Tuning antenna
coupler
The antenna coupler tunes in all frequency bands?
(TUNE OK)
Output power
The rated power is transmitted?
Receiver sensitivity
Check the receiver, receiving condition of atmospheric
noise, or receiving a signal such as time signal from a
convenient radio station.
Selftest
The results of selftest are OK?
Method of operation)
Turn RF VR to the maximum.
• FS-2550: [Cursor] + Power ON
• FS-1562: [Tx] + Power ON
Program version
The program version has been checked?
• FS-2550: [ENT] + Power ON
• FS-1562: [ENT] + Power ON
FS-5000
System setting
The necessary system setting has been made?
The system setting channel “9982” is set to “1”?
Pressing [STO] and [BFO] keys, check that the BFO
frequency is set to 1700 Hz.
Method of system setting
[STO]
→
Enter “system setting channel”
→
[ENT]
→
”Set”
→
[ENT]
Tuning antenna
coupler
The antenna tuns in all the frequency bands? (TUNE
OK)
Output power
The rated power is transmitted?
Receiver sensitivity
Check the receiver, receiving atmospheric noise, or a
signal such as time signal from a convenient radio
station.
Selftest
The results of the selftest are OK?
The selftest starts with a keystroke of [RCL], “9900”,
and [ENT].
Program version
The program version has been checked? The program
version of FS-5000T and FS-5000C must be the same.
To Next Page
Loading...
