Furuno RC-1800T - Automatic Printing of Display Log

4-27
4. To print the log, press and hold down [Ctrl] and press [P].
“Now printing” appears on the screen.
To stop printing, press [Esc].
display log description
S/R: Send or Receive message
Message No.: Message no. or file name
Type: Currently, TELEX, PSTN, PSDN or SPEC (2-
digit code service).
Pri: Normal or distress
Date: Date message was received (or transmitted).
Time: Time message was received (or transmitted).
LES: ID of LES which handled the message
Station: Transmitting station name. Blank for unregistered
station or receive message.
Size: Size of message in bytes
Cond: Transmission results. Blank if receive message.
Success: Successful transmission
Fail: Failed transmission
Rejected: Message rejected by LES
Automatic printing of display log
The Display Log can be automatically printed every 24 hours.
1. Press [F8] to display the Setup menu.
2. Press [6] to display the Auto Mode Setup menu.
Setup
7. E-Mail Setup
8. Directories
9. Configuration
Auto Mode Setup
Auto Log Print
Receive Alarm
Auto Telex Msg Save
Auto EGC Msg Save
OFF
ON
ON
OFF
Figure 4-38 Auto mode setup menu
3. Press [Enter] to open the selection window of Auto Log Print.
4. Set Auto Log Print to ON.
5. Press [Enter] to close the selection window.
6. Press [Esc] twice.