Furuno RC-1800T - Manual Entry of Position and Time

2-10
2.10 Manual Entry of Position and Time
If there is no EPFS (Electronic Position-Fixing System) connected to the DSC-60 or the EPFS
connected is inoperative, manually enter position and time as follows:
1. At the DSC standby screen, press the [#/SETUP] key to display the Setup menu.
****
Setup menu
****
SCAN FREQ
USER CH
VOLUME
TEST
SYSTEM
ALARM
AUTO ACK
ERASE
MESSAGE
POSITION
PRINT OUT
2. Select POSITION and press the [ENT] key to display the Position menu.
**
Position setup
**
INPUT TYPE: AUTO
LAT : 34˚ 41 NORTH
LON : 135˚ 30 EAST
TIME: 09: 00 UTC
3. Press the [ENT] key to open the INPUT TYPE menu.
**
Position setup
**
INPUT TYPE: AUTO
LAT : 34˚ 41 NORTH
LON : 135˚ 30 EAST
TIME: 09: 00 UTC
AUTO
N
MANUAL
Note 1:
If, when AUTO is selected, input from the navigator is interrupted the message
“EPFS error!” appears. If this occurs check the navigator.
Note 2:
If, when MANUAL is selected, the message “Warning: Update position” appears at
set intervals to ask you to update position. For further details see page 7-2.
4. Press

to select MANUAL and press the [ENT] key.
5. Press the [ENT] key to open the latitude entry window.
**
Position setup
**
INPUT TYPE: MANUAL
34˚ 41
LON : 135˚ 30 EAST
TIME: 09: 00 UTC
Note: Use 6 to switch from
North to South and vice versa.
LAT : 34˚ 41 NORTH
12
34 ˚ 41 N