1. INSTALLATION
1-9
1.3.2 How to flush mount the SC-702
There are two methods for flush mounting the SC-702. You can mount the unit directly
onto the mounting area, or use the optional front fixing panel kit.
For both flush mount installation methods, the hanger and knobs are not required. re-
move the unit from the hanger and discard the hanger and knobs.
Flush mounting the SC-702 (unit only)
1. Cut a hole in the mounting location, using the template at the back of this manual.
2. Drill four holes for the self-tapping screws (I5x20) at the installation location.
3. Place the SC-702 on a firm, flat surface, then unfasten the two knobs on either
side of the display unit to remove the unit. The hanger can be disposed.
4. Gently lift the locking tabs at the rear of the front panel, then remove the front pan-
el. Take care not to damage the locking tabs or the front panel.
5. Fit the F Mount Cushion Kit (code: 20-032-106, included) to the rear of the SC-
702 or to the mounting hole.
6. Run the cabling through the cutout, then, referring to section 1.5.6, connect the
necessary cabling to the SC-702.
7. Referring to the figure below, fit the SC-702 to the cutout, then use the supplied
self-tapping screws (I3u20) to secure the SC-702 to the flush mount panel.
8. Re-fit the front panel that was removed at step 4.
Rear view of SC-702
Lift these locking tabs
(8 locations)
Lift these locking tabs
(8 locations)
Front panelFront panel
Mounting hole
F Mount
Cushion
SC-702
Self-tapping screws (ø3×20, 4 pcs)
Self-tapping screws (ø3×20, 4 pcs)
Front panel
To Next Page
Loading...
