1. INSTALLATION
1-18
Note 2: Cable entrances 1 though 8 are protected from foreign materials with a small
plastic spacer. To use one these cable entrances, remove the spacer, then pass the
cable through.
The table on the following page indicates the recommended cable entrance, connec-
tor number and the cable type required for connections to the SC-701.
*: To remove the USB Flash Memory, see "How to remove the USB Flash
Memory" on page 3-4.
Note: For (JIS) cable equivalents, see the JIS cable guide at the back of this manual.
TB2 WAGO connector (9-pin, TTYCSLA-4)
TB3 to TB6WAGO connectors (7-pin, TTYCSLA-1/TTYCSLA-1Q)
External connection
Recommended
entrance
Connector
No.
Cable type
Power Power cable
entrance only
TB1 (JIS) DPYC-1.5
Shipboard network (AMS, etc.)
(IEC61162-450)
1, 2 or 9 J1 (JIS) FR-FTPC-CY
Antenna unit
(SC-703 or SC-1303)
9J3LAN
10 or 11 LAN-Coaxial
conversion kit
Existing coaxial.
AD-10 format data output 3 or 10 TB8 or TB9 (JIS) TTYCSLA-1Q
NMEA0183 (IEC61162-2) 3 or 10 TB7 (JIS) TTYCSLA-4
NMEA0183 (IEC61161-1) 4, 5, 6, 7 or
11, 12, 13, 14
TB3 to TB6 (JIS) TTYCSLA-1
or TTYCSLA-1Q
Display unit (SC-702) 15 only TB2 (JIS) TTYCSLA-4
CANbus 4, 5, 6, 7 or
11, 12, 13, 14
TB10 M12-05BFFM**
(“**” indicates
length)
USB Flash Memory* - USB port -
Pin
no.
Connection
(signal)
Description Remarks
1 P12V Power -
2 GND Grounding. -
3-
4-
5 TD6_A TX data Fixed at 115200 bps.
6 TD6_B TX data
7 RD6_A RX data
8 RD6_B RX data
9 GND Drain wire Connect to drain wire.
Pin
no.
Connection
(signal)
Description Remarks
1 TDx_1A TX data NMEA(Ver1.5/2.0/3.0/4.0),
IEC61162-1
2 TDx_1B TX data “x” denotes the connection to
terminals as shown below.
3 TDx_2A TX data Signal Terminal
4 TDx_2B TX data TD/RD5 TB3
To Next Page
Loading...
