1. INSTALLATION
1-22
How to fit the optional waterproofing kit (OP05-139)
The optional waterproofing kit must be fitted at the same time as the cabling is con-
nected to the SC-702.
Note: To satisfy the requirements for IPX5 waterproof rating, the cable used must
have a diameter of 14.4 mm (±0.4 mm).
1. Unfasten the four screws on the rear cable clamp, then remove the cable clamp
to reveal the WAGO connector.
2. Fit the cable gasket to the cable clamp, referring to the figure below.
3. Pass the cabling through the cable gasket and cable clamp.
4. Fit the cover gasket (rubber seal) to the rear of the SC-702. Make sure the rubber
seal is placed inside the groove indicated in the figure below.
5. Connect the cabling to the SC-702, referring to section 1.5.6.
6. Slide the cable clamp along the cable until the clamp is flush against the rear of
the SC-702.
Note: The cable clamp must be oriented with the dome facing upwards in order
to retain it’s waterproofing rating.
7. Fasten the four screws removed at step 1.
8. Secure the cables to the cable clamp with cable ties.
Fixing lip
Cable clamp Cable gasket
1. Fit the cable gasket to the cable clamp,
passing the fixing lip partially through
the cable clamp.
2. To pass the fixing lip completely
through the cable gasket, twist the
cable gasket gently.
3. Check that the cable gasket is flush
against the cable clamp, as shown
below.
4. Check that the cable gasket’s fixing lip
is flush against the inside of the cable
clamp.
Fixing lip
WAGO lever
Groove for
rubber seal
To Next Page
Loading...
