1. INSTALLATION
1-26
How to disable access to the menu
Where necessary, you can disable menu access by doing the following:
1. Open the [MENU].
2. Select [SYSTEM], then press the ENT key.
3. Select [PASSWORD], then press the ENT key.
4. Select [LOGOUT], then press the ENT key. The menu closes.
1.6.2 How to set vessel dimensions, antenna location and CCRP
Access to the [OFFSET] menu requires the [SERVICE] menu to be unlocked. To un-
lock the service menu, see section 1.7.
1. Open the [MENU].
2. Select [SENSOR], then press the ENT key.
3. Select [OFFSET], press the ENT key.
4. Select [DIMENSIONS/CCRP], then press the ENT key. The settings window ap-
pears. The figure below is an example of the settings window.
5. Select [EQUIPMENT NO.], then press the ENT key. The [INPUT EQUIPMENT
NO.] pop up window appears.
6. Set the antenna number you wish to set the location for.
7. Select [ENTER], at the bottom of the pop up window, then press the ENT key.
The antenna selected here is used to output the POS sentence to external equip-
ment.
8. Select [SHIP’S WIDTH], then press the ENT key. A numerical pop up window ap-
pears. Referring to the figure above, set the dimensions of the vessel.
9. Set [SHIP’S LENGTH] and [SHIP’S HEIGHT] in a similar manner.
10. Referring to the table below, set the antenna mounting position (CCRP) and the
speed calculation adjustments.
Note: These settings require CCRP and ship dimensions. Do step 5 and 6 before
changing these settings.
Indication Description Setting range
[ANT POSN X0] Port-starboard location of antenna
unit. Enter a negative value for port-
side, positive value for starboard-
side. The center of the vessel is [0
m].
- ([SHIP’S WIDTH]/2) to +
([SHIP’S WIDTH]/2).
For example, if the [SHIP’S
WIDTH] is set to [100 m], the
range is [-50 m] to [+50 m].
Number assigned
to this antenna
OS dimensions
Antenna unit
mounting
location
Corrections for
speed calculation
Dynamic antenna location indicator
To Next Page
Loading...
