1. INSTALLATION
1-27
*: These settings are required in order to display correct data on the SPD display.
See section 2.10.
11. To apply the settings, select [ENTER], then press the ENT key.
To discard the changes and start again, select [CANCEL], then press the ENT
key.
12. Close the [MENU].
1.6.3 How to apply offsets for heading/pitch/heave/roll/position
Note: Access to the [OFFSET] menu requires the [SERVICE] menu to be unlocked.
To unlock the service menu, see section 1.7.
1. Open the [MENU].
2. Select [SENSOR], then press the ENT key.
3. Select [OFFSET], then press the ENT key.
4. Referring to the table below, select the appropriate item to offset, then press the
ENT key.
5. Use the arrows key to set the offset, then press the ENT key.
6. Close the [MENU].
[ANT POSN Y0] Bow-stern location of the antenna
unit. Calculated from the center of
the stern.
[0.0 m] to [SHIP’S LENGTH].
For example, if [SHIP’S LENGTH]
is set to [45 m], the maximum
range for this setting is also [45 m].
[ANT POSN Z0] Height of antenna unit location, from
the bottom of the ship.
[0.0 m] to [99.9 m]
[CALC-SPD POSN Y1]* Ship’s speed can be measured at
two locations in addition to the an-
tenna position. Enter the forward dis-
tance, calculated from the CCRP, to
the location where you want to mea-
sure the ship’s speed.
[0.0 m] to [SHIP’S LENGTH].
For example, if [SHIP’S LENGTH]
is set to [45 m], the maximum
range for this setting is also [45 m].
[CALC-SPD POSN Y2]* [0.0 m] to [SHIP’S LENGTH].
For example, if [SHIP’S LENGTH]
is set to [45 m], the maximum
range for this setting is also [45 m].
[CALC-SPD POSN Z]* Enter 0 to calculate the height from
the bottom the ship. Enter the
draught amount to calculate the
height from the draught.
[0.0 m] to [ANT POS Z0].
Menu item Description Offset range
HDG OFFSET Offset the heading. -180° to +180°
PITCH OFFSET Offset to compensate for pitch. -10°000 to +10°000
ROLL OFFSET Offset to compensate for roll.
POSITION OFFSET Offset the Own Ship position. North/South: 00.0000’ to
59.9999’
East/West: 00.0000’ to
59.9999’
DIMENSIONS/CCRP Set the ship size, location of the
antenna and CCRP.
See section 1.6.2.
SOG OFFSET Offset the SOG. -12.5% to +12.5%
ATM OFFSET Offset atmospheric pressure. -99.9 hPa to +99.9 hPa
TEMP OFFSET Offset the temperature. -99.9°C to +99.9°C
Indication Description Setting range
To Next Page
Loading...
