Furuno SC-130 - How to Access the Alert List

2. OPERATION
2-17
2.11.3 How to access the alert list
The alert list shows all currently violated alerts and state of acknowledgment.
All unacknowledged alerts are shown, even those whose reason for the alert has bee
rectified or passed (except for cautions). To access the alert list, do the following:
1. Open the [MENU].
2. Select [ALERT], then press the ENT key.
3. Select [ALERT LIST], then press the ENT key. The list of active alerts appears.
4. Press S or T to scroll up or down through the alert log.
5. Press the DISP key to close the [ALERT LIST].
Note: You can also access the [ALERT LIST] from the [LIST] display. Press the LIST
key to cycle through the lists.
How to interpret the alert list
No. Indication name Description
1 DATUM/OS coor-
dinates
or
[HDG]/[ROT]
Where the device mode is [THD] or [ROTI]:
• [HDG]: OS heading, oriented to North. If the heading data
is received from an external device, the device name and
external input talker are shown.
• [ROT]: Rate of turn with arrow indicating turn direction to
port or starboard.
Where the device mode is [SPD] or [GPS]:
Datum and OS coordinates are displayed.
2 FIX Current position fixing method (GP-3D, GP-D3D, etc.)
3 CALC Calculation status.
• [NORMAL]: Data is calculated normally.
• [DR]: Data is calculated using Dead Reckoning.
• [STOPPED]: Data calculation stopped.
• [SYS FAULT]: System fault.
4 Alert icon Shows alert status. See page AP-8 for details.
5 Alert details Top line: alert code, alert message
Bottom line: time of alert, coordinates at time of alert.
Note: A full list of alert codes, meaning and measure is in-
cluded at "ALERT LIST" on page AP-4.
N
O
RMA
L
E
CKONIN
G
440301 DEAD R
E
S
ALERT LI
S
T
44
03
01
D
EA
D
E
E
E
E
E
RE
CK
CK
CK
CK
CK
CK
ON
ON
ON
ON
ON
ON
IN
IN
IN
IN
IN
IN
G
G
G
G
G
G
44
44
44
44
44
03
03
03
03
03
01
01
01
01
01
D
D
D
D
D
EA
EA
EA
EA
EA
D
D
D
D
D
RE
RE
RE
RE
RE